In-System Programming Cable
Solder one end of a 5 conductor ribbon cable to the top side
of a DIP socket.
Stack the socket on a second socket.
Wrap cellophane tape around the sides of the socket and underneath.
Fill the tape with epoxy.
Place cellophane tape sticky side up over short wire "pins" soldered
on the propeller's programming pads.
Remove 5 pins from a socket and solder the pin side to the other end of
the
ribbon cable.
place the socket pins on the correct wire pin on the propeller.
Form a cellophane tape wall around the socket pins stuck on the wire
pins.
Fill the tape wall with epoxy.
Remove the tape after the epoxy cures.